Assemble the Front Doors

1. Push a strip of rubber trim onto the edge of the window opening on each front door. Make sure that the trim starts at one end of the door handle mount, continues around the perimeter of the window, and ends at the opposite side of the door handle mount. When finished, use shears or a knife to cut the excess trim.
2. Remove and discard the protective plastic film from each window.

3. On the inside of one front door, put one window on top of the rubber trim.

4. Attach one dark gray, vertical window retainer to both sides of the front door's window opening with two sets of three M5 × 0.8 - 10 screws.

   To prevent window damage from over-tightening, use your fingers to tighten the screws.

5. Attach one dark gray, horizontal window retainer to the top and bottom of the front door's window opening with two sets of two M5 × 0.8 - 10 screws.

   To prevent window damage from over-tightening, use your fingers to tighten the screws.

   

   Window retainers attached to the front door.

6. Repeat Steps 1 through 5 to assemble the remaining front door.

1. Slide four door hinges into the notches on the left door window and right door window.

   

   Notches on the door windows.

2. Tighten the three set screws on each door hinge with a small, flat-blade screwdriver to secure it to the window.

   Discard any additional hardware that's included with the separately-packaged door hinges.

3. Determine the orientation of the doors: test fit each on the enclosure.
4. Set the right door window aside.

5. Attach the door edge to the left door window with two 8-32 × 1/2-inch Phillips screws and two 8-32 nuts.

   

   Door hinge attached to the door window.

6. Attach one large handle to the left door window opposite the door edge with two 8-32 × 1/2-inch Phillips screws.

   

   Large door handle location on the door window.

7. Tighten the screws on the large handle.